As the technology develops, your factory radio may not be compatible with many modern features at present. Under this circumstance, you can consider removing your factory radio and installing a new multifunctional car radio which is integrated with both practical and entertainment features. This passage mainly introduces a detailed 2009 2010 2011 2012 Mazda 3 car radio installation instruction. If your dashboard is the same as or similar to the image below, then you can carefully refer to the following instruction.
2009 2010 2011 2012 Mazda 3 Car Radio after installation
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2009 2010 2011 2012 Mazda 3 car radio installation instruction
1. The original car radio.
The original car radio
2. Use a flat removal tool to pry up the air vent.
Use a flat removal tool to pry up the air vent
3. Push it out towards you and put it aside.
Push it out towards you and put it aside
4. Use a screwdriver to remove the screws that are holding the original car radio.
Use a screwdriver to remove the screws that are holding the original car radio
5. Remove the original car radio out from the dashboard.
Remove the original car radio out from the dashboard
6. Unplug the connectors at the back of the original car radio. Please use a removal tool if necessary.
Unplug the connectors at the back of the original car radio. Please use a removal tool if necessary
7. Check all the accessories for the new Seicane car radio.
8. Connect the harnesses to the back of the new Seicane car radio.
9. Connect the Seicane car radio to your original car radio’s plugs.
10. Turn on the new Seicane radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
11. If the new Seicane car radio works well, put it into the dash.
12. Put everything into their original place, and all the installation is done.
If you encounter any problems before or during the installation, please feel free to consult your dealer or seek help from a professional. Additionally, you can also ask someone experienced to give you some advice. Or you can directly arrange a technician to help you install the new car radio.
Anyway, it is essential for you to select an ideal car radio for your beloved car. If you have no ideas, you can refer to the following link which is a great 2009 2010 2011 2012 Mazda 3 car radio from Seicane. For more details, please click:
This car radio is integrated with many main features that you are desirous of, including 3D GPS navigation, FM/AM radio tuner, DVD player, Bluetooth hand-free calls, Bluetooth streaming music, AUX, steering wheel control, USB/SD card connection, etc.
Under the guidance of turn-by-turn direction and voice prompts provided by the high accuracy 3D GPS navigation, it is much easier for you to know your current location and find the right way to arrive at your desired destinations. And this unit’s dual zone function enables you to listen to music while navigating.
Moreover, without taking your hands off the steering wheel, both hands-free calls and streaming music are available for you as long as you connect your Bluetooth-enabled mobile phone to this unit. So you can get a lot of convenience and enjoyment.
Wish you like this unit and good luck to you!
Recent Comments