When travelling with your families or friends, you must want to keep them entertained all the way. Under this circumstance, you can upgrade your factory radio with a brand new car radio which supports a variety of multimedia features. To help with your new car radio installation, I’d like to share a detailed installation instruction about a 2007-2012 GMC Yukon Bluetooth dvd car radio with you. If you have a same or a similar dashboard as the following image from Seicane, it suggests you to read it carefully.
2007-2012 GMC Yukon Bluetooth dvd car radio after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2007-2012 GMC Yukon car radio installation instruction
1.Remove panel holding access to fuses in driver side.
Remove panel holding access to fuses in driver side
2.Remove two screws under steering wheel column panel.
Remove two screws under steering wheel column panel
2-1
3.Remove one bolt from the same area.
Remove one bolt from the same area
4.Remove steering wheel column panel by pulling back to release clips.
Remove steering wheel column panel by pulling back to release clips
5. Use a plastic knife to release clips by pulling panel outwards.
Use a plastic knife to release clips by pulling panel outwards
6.Remove bolts holding in ac controls.
Remove bolts holding in ac controls
7. Pull out the AC controls.
Pull out the AC controls
8.Remove bolts holding in factory stereo.
Remove bolts holding in factory stereo
9.Remove factory stereo and unplug connectors.
Remove factory stereo and unplug connectors
10. Check all the accessories for the new Seicane car stereo.
11. Connect the harnesses to the back of the new Seicane car stereo.
12. Connect the Seicane car stereo to your original stereo’s plugs.
13. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
14. Put the new Seicane car stereo into the dash.
15. Put everything into their original place. All the installation is done.
Wish you succeed in install a 2007-2012 GMC Yukon Bluetooth dvd car radio under the guidance of the 2007-2012 GMC Yukon Bluetooth dvd car radio installation guide. Don’t worry if you cannot deal with some problems independently. You can consult your dealer or ask someone experienced to help you. If you think it impossible for you to finish the whole installation, you’d better go to a car stereo upgrade center to install your new car radio.
To help you find a suitable car radio, I would like to recommend you a great 2007-2012 GMC Yukon Bluetooth dvd car radio from Seicane which comes with both practical and entertaining features. Please click it for more details.
This intelligent 2007-2012 GMC Yukon Bluetooth dvd car radio will be one of your good choices to upgrade your factory radio because of its various features. This unit comes with a 7 inch HD 1024*600 resolution multi-touch screen, which brings you the best visual effect and makes your operation easier, faster and smoother. Moreover, you can enjoy your driving all the way with its built-in GPS Navigation system as well as multimedia player which supports various formats, such as DVD, VCD, MP3,MP4, etc. Good luck to you!
Recent Comments