To install a new car stereo to replace the factory radio on one’s own not only saves money but also raises the sense of achievement, therefore, more and more car owners try to install the new car stereo on their own and they did it finally. If you have some related installation experience and a correct installation guide, you can also achieve it by yourself. Please look at the picture below, it’s a modern 2010-2013 VW Volkswagen Multivan car stereo from Seicane, if your dashboard is the same as it, you can take this VW Volkswagen Multivan car stereo installation guide as a reference.
2010-2013 VW Volkswagen Multivan car stereo after installation
Precautions for this installation:
1.Before you start up any work, park your car well and unplug the negative power cable to avoid any danger.
2.Please make sure that all fastened wires are isolated with electrical tape.
3.Please make sure the ignition is off to avoid short circuit.
2010-2013 VW Volkswagen Multivan car stereo installation guide
Step1: Remove the trim panel.
Please pry around the trim panel with a lever. While prying, please loosen the trim panel with your hand. When the trim panel is loosened, please remove the trim panel off the dashboard and gently place it aside for further removal.
2010-2013 VW Volkswagen Multivan car stereo installation step 1
Step2: Remove the four screws on the radio.
Please unscrew the four screws which are holding the radio at four corners with a screwdriver. Then keep them well in a small box for the installation of a new radio.
2010-2013 VW Volkswagen Multivan car stereo installation step 2
Step3: Take the factory radio out of the dash.
After the four screws are unscrewed, you can easily pull the factory radio out of the dash.
2010-2013 VW Volkswagen Multivan car stereo installation step 3
Step4: Disconnect the wiring harness.
Before you put the factory radio aside, please disconnect the wiring harness at the back of it.
2010-2013 VW Volkswagen Multivan car stereo installation step 4
Step 5: Connect the new Seicane car stereo to the original wiring harness as the user manual or the wiring diagram shows.
Step 6: Turn on the new Seicane car stereo to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
Step 7: Put the new Seicane car stereo into the dash and install four screws.
Step 8: Install the trim panel into its original place.
The installation is actually quite easy. Wish the above installation guide can do some help for you. If you have any questions, please consult your dealer or a professional for help. If you find the dashboard above is different from yours, please don’t worry, it won’t have much influence on the installation. If it’s the first time for you to install a new car stereo, you’d better go to a car stereo upgrade center or ask a professional for help.
What’s more, you need to pick a right stereo for you car to ensure it can be installed in your car without any gap. If you don’t have one, you can refer to an amazing 2010-2013 VW Volkswagen Multivan car stereo from Seicane, please click the following link:
This VW Volkswagen Multivan car stereo comes with a 3D GPS navigation system of high precision, you are allowed to go anywhere without getting lost any more. Thanks to the advanced Bluetooth technology, you can simply pair your mobile phone with this unit for having hands-free calls and enjoying music streaming from the playlist in your phone or other portable devices.
Improve your in-car environment and driving experience to next level, this intelligent VW Volkswagen Multivan car stereo is just your best choice. Just go and enjoy the wonderful time with it in your beloved car.
Recent Comments