Car stereo audio after installation,dvd GPS navigation system of 2006-2011 Mitsubishi outlander.
Car stereo audio after installation,dvd GPS navigation system of 2006-2011 Mitsubishi outlander
Upgrading car stereos can be a self-done thing in recent years,because there are a lot of materials on the Internet which can help you achieve this goal.
So if you are a owner of 2006-2011 Mitsubishi outlander,installing a dvd player with navigation system for your car by yourself is also very possible to realize when you have known easy installation steps for 2006-2011 Mitsubishi outlander navigation system support Mp3 Mp4.
Before you upgrade car audio system,you need to make adequate preparations for this process.Such as reading some essaies,watching videos,visiting some websites and so on.And you need to make these preparations including preparing removal tools after you have made it very clear.
Another question that you have no idea is that whether the aftermarket Mitsubishi outlander navigation system fits your car,here is a method for you:have a careful look at its trim panel and see if it’s same with your factory one’s.
2006-2011 Mitsubishi outlander car stereo removal and installation:
1.Open up the glove compartment
Open up glove compartment
2.Get out screw to side panel,then remove side panel
Get out screw to side panel
3.Gently drag trim piece toward seat place
remove side panel by pulling toward seat
5.Use panel removal tool,gently pry edges around stereo face
use your hand or panel removal tool,gently pry around edges of stereo face
6.Disconnect this cable,and do not start your car at that time
Disconnect the connector
7.Get four screws holding stereo in place out
Make out four screws holding stereo in place
8.Get out stereo for access to harnesses behind it
Get out stereo for access to harnesses behind it
9.Get out smaller connector to give access to Grom Y-harness, plug Grom harness into open port, connect removed harness to Grom Y-harness, Make 20-pin harness connected to Grom unit
Get out smaller connector to give access to Grom Y-harness
plug Grom harness into open port
connect removed harness to Grom Y-harness
Make 20-pin harness connected to Grom unit
10.Use provided P-Tap to make connection,please have a check that if P-Tap has punctured wire and is tightly secured
Use provided P-Tap to make connection
11.Plug stripped wire in as far as possible as the picture show
Plug stripped wire in as far as possible as the picture show
12.Secure cap tightly and tug on wire to ensure it is secured
Secure cap tightly and tug on wire to ensure it is secured
13.After finishing cables connection,turn on new stereo and check new unit and hope that you can enjoy a good time with new audio system
I guess most of you are not very clear about operations for this dvd,you can visit next website for more detailed usful knowledge: http://www.seicane.com/digital-touch-screen-car-dvd-player-gps-navigation-specialized-for-2006-2011-mitsubishi-outlander-with-radio-bluetooth-usb-sd-3g-wifi-c056.
If you are also interested in the installation affairs about Mitsubishi L200 navigation,you can go to and have a look at it.
Recent Comments