It’ s been a normal phenomenon that more and more car owners are using new aftermarket head units in their cars, because they can bring them much convenience as well as enjoyment at the same time. If you are also going to upgrade your factory radio, then you can read this Seicane 2002 2003 2004 Range Rover car stereo installation instruction carefully. The image below is taken after the new unit is installed for you to have a reference.
2002 2003 2004 Range Rover car stereo after installation
Precautions for this installation:
1.Before you start up any work, park your car well and unplug the negative power cable to avoid any danger.
2.Please make sure that all fastened wires are isolated with electrical tape.
3.Please make sure the ignition is off to avoid short circuit.
- 2003 2004 Range Rover car stereo installation guide
1.The original dashboard.
1.The original dashboard.
2.Use a plastic trim tool to remove trim strip.
2.Use a plastic trim tool to remove trim strip.
3.Remove screws marked by red arrows.
3.Remove screws marked by red arrows.
4.Take out original DVD player of the car.
4.Take out original DVD player of the car.
5.Pull out original power plug of the car.
5.Pull out original power plug of the car.
6.Connect the power cables as the picture shows.
6.Connect the power cables as the picture shows.
7.Remove screws in the spare tire in the trunk.
7.Remove screws in the spare tire in the trunk.
8.Take out the spare tire.
8.Take out the spare tire.
9.Remove four screws marked with red arrows.
9.Remove four screws marked with red arrows.
10.Remove screws in triangle crutch.
10.Remove screws in triangle crutch.
11.Take out triangle crutch.
11.Take out triangle crutch.
12.Connect original plug of the car with power plug of DVD GPS.
12.Connect original plug of the car with power plug of DVD GPS.
- Connect the new Seicane car stereo to the original wiring harness as the user manual or the wiring diagram shows.
- Turn on the new Seicane car stereo to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
- Put the new Seicane car stereo into the dash and install the four screws.
- Install the trim panel into its original place.
Warning:
Please don’t pull out the GPS SD card with the power on in case of data corruption.
Installation tips for the GPS antenna.
Please don’t shorten or lengthen the GPS antenna to avoid a short circuit or antenna problems. Please place the antenna on the dashboard or on the roof of the car in a horizontal position as best as possible. If there if any film on the windows and heat insulation in the car, it may have a direct effect on the GPS antenna, like positioning precision and signal intensity.
Wish you can get some help from the above instruction. If you have any question, you can consult your dealer or a professional. Please make sure you are clear every step before you start to install. If you are a green hand on the installation, it’s suggested you ask a professional to help you. If you don’t have a fitting car stereo for your car, I’ d like to introduce a powerful 2002 2003 2004 Range Rover car stereo from Seicane to you, please click for more details:
This intelligent Range Rover car stereo comes with an accurate GPS navigation system to lead you to any hard-to-find location within the least time and in the most precise direction. It also comes with an integrated DVD player for you to keep your passengers pleasant on long trips. Besides, you can simply sync with your enabled mobile phone for hands-free calls and streaming music via the bluetooth connection.
To get to your desired destination with ease, this intelligent Range Rover car stereo is just your best choice! Take it right now and go!
Recent Comments