If you are fed up with your factory radio since it is too outdated to be compatible with a lot of modern features, it is suggested that you consider replacing your factory radio with a new aftermarket car radio. While for the installation, if you would like to remove the factory radio and install the new car radio by yourself, you can refer to a related correct guide. The following is a 2003 2004 2005 2006 2007-2010 Skoda Roomster car radio installation guide from Seicane. If you have the same or similar dashboard, you can take this guide as a reference.
Precautions for this installation:
1. Before you start up any work, park your car well and unplug the negative power cable to avoid any danger.
2. Please make sure that all fastened wires are isolated with electrical tape.
3. Please make sure the ignition is off to avoid short circuit.
4. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2003 2004 2005 2006 2007-2010 Skoda Roomster car radio installation guide
1. Remove the top panel with a lever.
2. Disconnect the connector at the back of the panel.
3. Unscrew the screw with a screwdriver.
4. Remove the metal sheet on the top with your hands.
5. Unscrew two screws circled in red shown as follows under the metal sheet.
6. Remove the air conditioner vent with your hands.
7. Unscrew two screws under the vent with a screwdriver.
8. Remove the panel on the original car radio.
9. Unscrew four screws holding the original car radio with a screwdriver.
10. Take the original car radio out of the dash.
11. Disconnect all the connectors at the back of the original car radio.
12. Check all the accessories for the new Seicane car radio.
13. Connect the harnesses to the back of the new Seicane car radio.
14. Connect the Seicane car radio to your original car radio’s plugs.
15. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
16. Put the new Seicane car radio into the dash.
17. Put everything into their original place.
Whether you have any doubts about the new car radio or the installation, please don’t hesitate to consult your dealer, communicate with someone experienced or turn to a professional for help. Besides, if you are afraid of making damage to either your car radio or your car, you can directly go to a car radio upgrade center and arrange a professional technician to help you install the new car radio. To help you install the new car radio, here I would like to share an amazing 2003 2004 2005 2006 2007-2010 Skoda Roomster car radio from Seicane with you. For more details, please click:
Upgraded to the advanced and stable Android 7.1 operation and a powerful quad-core CPU processor as well as 2GB RAM, this car radio can provide the much smoother, faster and easier operation experience for you.
With the guidance of the turn-by-turn directions and voice prompts offered by the 3D GPS navigation system of high accuracy, you can quickly know your current locations and accurately navigate to any locations you would like to go to. Besides, this unit comes with dual zone function, which enables you to listen to your favorite music while navigating. And the music will automatically switch to GPS voice automatically.
What’s more, by paring your Bluetooth-enabled mobile phone with this car radio, you can freely dial, answer, reject and mute Bluetooth hands-free phone calls as well as freely enjoy Bluetooth streaming music from your phone playlists without taking your hands off the steering wheel control.
If you like this unit, just add it to your shopping cart. Good luck to you!
Recent Comments