Are you desired a more relaxing and comfortable driving experience while you are navigating to your destination? Most of car owners definitely say yes. In that case, you can simply upgrade your factory radio with a new multifunctional head unit which can bring a lot of convenience and enjoyment for you. And you don’t have to worry about the installation which is actually not too complicated. Now I’d like to share a detailed 2006 2007 2008 Dodge Caliber head unit installation guide from Seicane with you. If you have the same dashboard as that shown in the image below, then you can take it as a reference.
2006 2007 2008 Dodge Caliber head unit after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
2006 2007 2008 Dodge Caliber head unit installation guide
1.Loosen the trim panel with a lever.
1.Loosen the trim panel with a lever
2.Take the panel off the dash and disconnect the wires from the car.
2-1.Take the panel off the dash and disconnect the wires from the car.
2-2.Take the panel off the dash and disconnect the wires from the car.
3.Remove the four screws which are holding the unit with a screwdriver.
3.Remove the four screws which are holding the unit with a screwdriver.
4.Take out the unit and disconnect the wire harness at the back of the unit.
4-1.Take out the unit and disconnect the wire harness at the back of the unit.
4-2.Take out the unit and disconnect the wire harness at the back of the unit.
5.Connect the new wiring harness adaptor to the car, then, to the unit.
5-1.Connect the new wiring harness adaptor to the car, then, to the unit.
5-2.Connect the new wiring harness adaptor to the car, then, to the unit.
6.Connect the wire as the user manual shows and put the new unit into the dash.
6.Connect the wire as the user manual shows and put the new unit into the dash.
7.Turn on the new unit and have a test if the new Seicane unit is working without problem..
8.Put trim panel back on your new Seicane unit after the normal test.
Can you install your new Dodge Caliber head unit on your own under the guidance of this instruction? If not, you’d better ask a professional for help. Please make sure you are clear about every step before you start your work. In addition, you need to confirm you have a fitting unit for your car, if you don’t have one, I’d like to recommend this amazing Dodge Caliber head unit from Seicane to you, please click:
No matter you are going to have a long travel or find a new restaurant for your family, you can take this magic Dodge Caliber head unit with GPS navigation system to get the lane assist, 3D street view, landmark display, route planning, thousands of points of interest, turn-by-turn direction and voice prompts. What’s more, thanks to a number of audio and video formats to be supported, this multimedia player can must relax and amuse both you and your passengers on the way.
Recent Comments