Have you noticed that your factory radio cannot be compatible with some modern features after being used for a long time. Under this circumstance, you can consider replacing your factory radio with a brands new multifunctional car radio which can meet your various needs in car. The following is a 2017 KIA RIO car radio installation instruction. If you have the same or similar dashboard, you can refer to this instruction and take it as a reference.
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape.
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2017 KIA RIO car radio installation instruction
1. Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside.

Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside
2. Remove screws that fixed the radio on the dashboard.
3. Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio.

Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio
4. Unplug the connectors at the back of the factory radio.
5. Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure.

Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure
6. Put the new Seicane radio into your car, you should check whether your connections are correct, and you’d better have a tidy for the cables.
7. If everything is OK, firm screws into their original place.
8. Firm the panel on the new Seicane radio. Finally the new Seicane radio is installed and a comprehensive test should be conducted on the new radio.

Firm the panel on the new Seicane radio. Finally the new Seicane radio is installed and a comprehensive test should be conducted on the new radio
If you cannot totally understand all the above installation steps, you can contact your dealer, communicate with someone experienced or turn to a professional for help. Or if you still think it hard to finish the whole installation process, you can directly arrange a professional technician to help you install the new car radio. While for the selection of an ideal car radio, if you have no ideas, you can check out the following link which is an amazing 2017 KIA RIO car radio from Seicane. For more details, please click:
This intelligent car radio, upgraded to the latest firmware and software, can be regarded as one of the best replacement for your factory radio in your car.
With the assistance of the worldwide real-time GPS navigation system of high accuracy, this car radio enables you to easily locate where you are and navigate to your desired destinations according to turn-by-turn directions and voice prompts. And this unit’s dual zone function enables you to listen to your favorite music while navigating.
Besides, under wireless Bluetooth technology, as long as you connect your Bluetooth-enabled mobile phone to this car radio, you are able to dial, answer, reject and mute hands-free phone calls as well as listen to Bluetooth streaming music from your phone. Therefore, you will gain a lot of convenience and enjoyment.
If you like this car radio, just don’t forget to add it your shopping cart. Good luck!
Recent Comments