If you are not satisfied with your original car radio due to its single function which cannot help you gain a brand new driving experience, then you can consider replacing it with a brand new multifunctional car radio. If you have a 2007-2013 Jeep Wrangler Unlimited, to help you have a better understanding of the related car radio installation, a detailed car radio installation guide may be much helpful for you. The following is a 2007-2013 Jeep Wrangler Unlimited car radio which can be taken as a reference.
2007-2013 Jeep Wrangler Unlimited Stereo after installation
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2007-2013 Jeep Wrangler Unlimited car radio installation guide
1. The original car radio.
The original car radio
2. Remove the panel by prying the edges with a lever.
Remove the panel by prying the edges with a lever
3. Unscrew four screws holding the original radio in place with a screwdriver.
Unscrew four screws holding the original radio in place with a screwdriver
4. Take the original radio out of the dash.
Take the original radio out of the dash
5. Disconnect the connectors at the back of the original radio.
Disconnect the connectors at the back of the original radio
6. Check all the accessories for the new Seicane car radio.
Check all the accessories for the new Seicane car radio
7. Connect the harnesses to the back of the new Seicane car radio.
Connect the harnesses to the back of the new Seicane car radio
8. Connect the Seicane car radio to your original car radio’s plugs.
9. Turn on the new Seicane radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
10. Put the new Seicane radio into the dash.
11. Put everything into their original place.
Wish the above installation guide can offer you some help to some degree. If you have any doubts, please don’t hesitate to consult your dealer, someone experienced or a professional. For avoiding damage to your car or your new car radio, you can also go to a car radio upgrade center to ask a professional technician to install the car radio directly. Besides, it is very essential for you to confirm that you’ve already got a suitable car radio for your car. If you have no ideas, I’d like to share a 2007-2013 Jeep Wrangler Unlimited car radio from Seicane with you.
Featured with a wide range of upgraded functions, this smart car radio specific for 2007-2013 Jeep Wrangler Unlimited enables you to make your Bluetooth-enabled mobile phone wirelessly sync with this unit to dial, receive, reject and mute hands-free calls for convenience and safety as well as enjoy streaming music for enjoyment under the wireless Bluetooth technology.
You don’t have to worry about getting lost in an unfamiliar location even you don’t have a good sense of directions. With the help of 3D GPS navigation system, you can easily know your current location and find the most suitable way to arrive at your desired destinations according to turn-by-turn directions and voice prompts.
If you like this car radio, don’t hesitate to add it to your shopping cart. Wish you have a nice trip accompanied by it. Good luck to you.
Recent Comments