For the upgrade of the factory radio, some car owners are still worry about that it is too hard to install a new car radio. Actually, the installation of a new car radio is not difficult because it is plug-and-play. You can try to find a correct installation guide to help with the installation. Now I’d like to share a step-by-step 2011- Dodge Attitude GPS Bluetooth DVD Car Radio installation guide from Seicane for your reference.
2011- Dodge Attitude GPS Bluetooth DVD Car Radio after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2011- Dodge Attitude car radio installation guide
1. Use a plastic removal tool to pry the trim panel and remove it.
Use a plastic removal tool to pry the trim panel and remove it
1-1
2. Disconnect connectors at the back of the panel.
Disconnect connectors at the back of the panel
2-1
3. Unscrew four screws that fixed the radio on the dashboard.
Unscrew four screws that fixed the radio on the dashboard
4. Gently take out the original radio.
Gently take out the original radio
5. Unplug connectors and cables at the back of the radio.
Unplug connectors and cables at the back of the radio
6. Check all the accessories for the new Seicane car radio.
7. Connect the harnesses to the back of the new Seicane car radio.
8. Connect the Seicane car radio to your original radio’s plugs.
9. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
10. Put the new Seicane car radio into the dash.
11. Put everything into their original place. All the installation is done.
That’s all about how to remove and install a 2011- Dodge Attitude GPS Bluetooth DVD Car Radio. Before the installation, please make clear every detailed step. If you cannot understand the steps, you can contact your dealer for seeking advice or ask a professional to help you. Anyway, first of all, please make sure that your new car radio can be perfectly installed in your car and can work well in your car. If not, you’d better quit it and purchase another suitable one. Here I’d like to share a 2011- Dodge Attitude GPS Bluetooth DVD Car Radio from Seicane with you, please click the link below for more information.
Upgraded to the most advanced hardware and software, this 2011- Dodge Attitude GPS Bluetooth DVD Car Radio is ideal enough to be the best replacement for your factory radio. The high-end 3D GPS navigation system of high accuracy enables you to have the best route option to reach your desired destination without mistakes with the turn-by-turn direction and voice prompts. Moreover, the Bluetooth technology allows you to pair your Bluetooth-enabled cell phone with this radio, so that you can have hands-free calls and stream music from your mobile phone focusing on the road ahead without keeping your hands off the steering wheel.
Wish you’ll have a good time with this 2011- Dodge Attitude car radio. Good luck to you!
Recent Comments