To cut down your budget on upgrading a factory radio, would you like to install a new car radio by yourself? You may think is too hard for you to install a new car radio on your own, however, it can be achieved if you follow a correct installation guide and have some related experience for better. An installation guide for a 2013 2014 2015 Honda JADE Car Audio Radio GPS Navigation System is as follows. If you have a same vehicle type, you may refer to it.
2013 2014 2015 Honda JADE Car Audio Radio GPS Navigation System after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2013 2014 2015 Honda JADE car radio installation guide
1. Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside.
Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside
2. Remove screws that fixed the radio on the dashboard.
Remove screws that fixed the radio on the dashboard
3. Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio.
Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio
4. Unplug the connectors at the back of the factory radio.
Unplug the connectors at the back of the factory radio
5. Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure.
Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure
6. Put the new Seicane radio into your car, you should check whether your connections are correct, and you’d better have a tidy for the cables.
7. If everything is OK, firm screws into their original place.
If everything is OK, firm screws into their original place
8. Firm the panel on the new Seicane radio. Finally the new Seicane radio is installed and a comprehensive test should be conducted on the new radio.
Firm the panel on the new Seicane radio. Finally the new Seicane radio is installed and a comprehensive test should be conducted on the new radio
Wish you can get some help from the above installation guide. If you cannot totally understand the steps, please don’t hesitate to consult your dealer, someone experienced or a professional. To upgrade your radio successfully, it is very important for you to choose a car radio which is compatible with your car. If you are still searching for it, I’d like to recommend a 2013 2014 2015 Honda JADE Car Audio Radio GPS Navigation System from Seicane with you. You may check out the link below for more information.
This powerful car radio for 2013 2014 2015 Honda JADE is advanced enough for you to upgrade your in-car environment and your driving experience. The latest 3D GPS system of high accuracy with turn-by-turn directions and voice prompts can lead you to your ideal destinations. Besides, as to the entertainment options, you don’t have to worry. There are different audio and video formats supported which can greatly enrich your entertainment experience, such as region-free DVD, VCD, CD, MP3, and DIVX, you can play anything you like to relax both yourself and your passengers. If you like it, don’t forget to take it home.
Recent Comments