It’s true that in recent society people are always seeking for more pleasure from busy life,because we may need to free ourselves especially after we have worked for a long time.A lot of people are more willing to buy a new vehicle because it will bring them much entertainments and convenience.If you are a owner of 2003-2010 VW Touareg,this essay will show some key steps of installation guide for 2003-2010 VW Touareg dvd bluetooth with autoradio navigation.
Before knowing how to remove original CD player and install a new one,we may have a look at this image,head unit after installation,dvd bluetooth with gps nav system of 2003-2010 VW Touareg:
You can make a comparision between your car radio with it,and see whether the dashboard of them are same.If they are in same scale,it means that this stereo radio can also be mounted in your car.
Actually it’s not hard,but simple doesn’t mean that we have no need to note anything,please turn off all your car series to ensure security.And you need to mind whether dvd player enters heat protection mode when the car is operated at very fast speed for a long time or the temperature of it is very high.If you decide to install a new radio for your beloved car,you can have a good look at the following installation guide and operate it step by step.
1.Original dashboard of VW Touareg car radio
2.Make four small levers inserted in the gap of radio
3.Get them tight into the gap and then take out CD player by pulling off the levers
4.Use a tool like the picture show to fasten lever and then you can remove four levers
5.Disconnect this big cable
6.Fasten this screw with a small special screwdriver and connect most fine wire to it
7.After that get inner wire out and take out a blue one and then plug it into white one of new unit,with the other white one inserted into blue one’s original place
8.Connect it to right place,put wiring in and turn on the radio and check whether all functions can work well
The installation for VW Touareg dvd bluetooth with stereo autoradio gps is finished here.Before you install,you should be careful that new unit antennas must be connected to right positions.After that, slide the unit into the dash then connect the negative cable to the original wiring harness as the steps show. Turn on new unit and check out all functions in the unit to see whether everything works well. If it doesn’t, check the wires connections again or talk with the technicians from the dealer for help,or you can visit some websites which may benefit you a lot, for example:
Recent Comments