Head unit after replacement,aftermarket gps radio with sat nav system touch screen of 2009 KIA Sportage.Have a careful look at trim pane of it and then your factory radio’s,for most of you may haven’t changed the stereo for your car.
Head unit after replacement,aftermarket gps radio with sat nav system touch screen of 2009 KIA Sportage
Knowing the installation guide for 2009 KIA Sportage aftermarket sat nav system clearly is very necessary if you are willing to install one by yourself,in fact there are a lot of people make such a choice.
We can find that people nowadays are more likely to seek for entertainments from usual life.Though most of the time we are rushing for life but we also should learn to enjoy it.More and more people choose to buy a new car because it will bring them much entertainments and convenience.If you have a KIA Sportage in 2009,this article is just for you.
To be honest,you can of course ask a professional worker to do it,however it’s not difficult to achieve though you are not professional only if you can make adequate preparations for it and be careful enough.But simple doesn’t mean we can do as what we want without obeying any rules,here are some attentions for you.
Precautions about installation and this new unit:
Make sure that you have finished all parking series to ensure security.When the car is operated at very fast speed for a long time or when you feel the temperature is very high you need to pay more attention to your new radio,new unit may enter heat protection mode at this time.If you have made up your mind to install a new unit,you can have a patient look at the following instructions and then operate the machine step by step.
2009 KIA Sportage factory audio removal:
1.Use a hard lever pry dashboard’s downer part,and you should try several places of it to fasten it totally
Use a hard lever pry dashboard’s downer part
2.Then you can take out dashboard easily
take out dashboard
3.We can find that there are cables connected the dashboard,so we need to unplug the cables.Some of them may be very tight,you can unplug it with a lever
disconnect the cables
unplug tight cable with a lever
4.Take four screws out with a screwdriver
Take this screw and the other corresponding one out with a screwdriver
Take this lower screw and the other corresponding one out with a screwdriver
5.After that you can get original radio out
get original radio out
6.Unplug cables behind the radio
Unplug cables behind the radio
Removal affairs has been finished,next we will go on learning how to install KIA Sportage aftermarket sat nav system.In fact it’s easier than front process only if you can do a good cables connection.
2009 KIA Sportage aftermarket stereo installation:
7.Plug those cables correctly to sockets of new radio and then set it into place just for it
8.Firm four screws to original positions and cover dashboard to it
I have confidence in you that nothing will impede you from achieving this goal after scanning these specific introduction patiently.I guess there are still some people who are not very familiar with new installed unit,then I suggest you to visit next website to gain detailed knowledge about it:http://www.seicane.com/2009-kia-sportage-multimedia-dvd-receiver-with-7-motorized-touchscreen-3g-wifi-ipod-input-support-gps-bt-radio-tuner-3-zone-pop-c023-1.
If you can provide your car gps dvd with good mount and maintain,it will surely make your usual life more richful.I hold that it can ensure your radio’s longer usage if you can install the unit according to correct steps.And when you meet some problems that really troubles you,then you’d better ask someone who knows better to have a check,you are not professional after all.
Recent Comments