Have you covered some materials about upgrade for 2010 2011 Mitsubishi Lancer autoradio?If you are interested in installing a new head unit into your car,then you answer is probably yes.And today I’d like to show you specific installation steps for 2010 2011 Mitsubishi Lancer double din radio dvd support HD 1080P video.
Let’s have a look at a picture first,which is new unit after installation,GPS dvd player with touch screen rearview camera of 2010 2011 Mitsubishi Lancer.Showing this image is to provide a comparison for you to judge that if this unit can be installed in your car though you are not a owner of 2010 2011 Mitsubishi Lancer.
new unit after installation,GPS dvd player with touch screen rearview camera of 2010 2011 Mitsubishi Lancer
It’s not right to hold that a stereo is only for one car,while it may fit several cars actually,this is very possible.And the principles of it are almost same and has little difference.Thus on matter whether this nav radio installation guide is just for you,you can still have a patient reading and learn something which will benefits you.
We can see that roads are increasing very rapidly and become more complex,so GPS navigation system is very necessary to most drivers,it’s difficult for us to remember all routes in a place especially when we are in a strange place.Therefore many people begin to realize the importance of it.But they are too busy or don’t know how to achieve it,so many willing drivers haven’t achieved this goal.
And today I will give you some advices on how to remove and install the head unit of 2010 2011 Mitsubishi Lancer.Don’t be afraid of following number for step,in fact they are not hard to behave.
2010 2011 Mitsubishi Lancer radio head unit removal and installation:
1.Open up glove box
Open up glove box
2.Take screw out to side panel
Take screw out to side panel
3.Take side panel out by pulling toward seat
Take side panel out by pulling toward seat
4.Take screw out to trim panel
Take screw out to trim panel
5.Pull trim piece toward seat softly
Pull trim piece toward seat softly
6.Once trim piece is released,remove trim panel with panel removal tool or your hands
remove trim panel with panel removal tool or your hands
7.Several clips across trim panel which holds trim piece in place
Several clips across trim panel which holds trim piece in place
8.Please note that do not take these three screws out
do not take these three screws out
9.Gently prize around edges of stereo face with panel removal tool
Gently prize around edges of stereo face with panel removal tool
10.After removing stereo face,tab along edges of stereo which hold stereo
tab along edges of stereo which hold stereo
11.Disconnect the cable,and do not turn on vehicle at that time
Disconnect the cable
12.Take four screws holding stereo in place out
Take four screws holding stereo in place out
13.Take stereo out for access to harnesses behind it
Take stereo out for access to harnesses behind it
14.Take smaller connector out to give access to Grom Y-harness
Take smaller connector out to give access to Grom Y-harness
15.Make Grom harness into open port connected
Make Grom harness into open port connected
16.Plug harness which is removed to Grom Y-harness
Plug harness which is removed to Grom Y-harness
17.Connect 20-pin harness to Grom unit
Connect 20-pin harness to Grom unit
18.Separate and check wire for +12v constant
Separate and check wire for +12v constant
19.With+12v constant confirmed,make connection with provided P-Tap,please ensure P-Tap has punctured wire and is tightly secured
make connection with provided P-Tap
20.Fasten top cap and then connect Yellow power wire
Fasten top cap and then connect Yellow power wire
21.Plug stripped wire as far as possible
Plug stripped wire as far as possible
22.Secure cap tightly and tug on wire to ensure it is secured
Secure cap tightly and tug on wire to ensure it is secured
23.After making all connections,turn on stereo and test new unit and hope that you can enjoy your new audio system
Please check radio appearance and all functions to make sure they can work well before you start to upgrade car stereo and replace a new unit.After that you only can start up to make your Mitsubishi Lancer radio more wonderful by yourself.
If you need to know more details about new features of new installed dvd display,you can visit the following website which has a lot of information there: http://www.seicane.com/double-din-2010-2011-mitsubishi-lancer-aftermarket-gps-radio-system-tv-tuner-cd-dvd-player-3g-wifi-pop-dvr-hd-1080p-video-backup-camera-ipod-iphone-c037.
Recent Comments