How hard is it to install a new car stereo in your beloved car? As a matter of fact, to install a new car stereo just takes several simple steps. Before the installation, what you have to do is to remove the original car radio. This article is mainly about how to remove and install a 2002-2010 Chrysler Sebring PT Cruiser car stereo. If you happen to have the same dashboard or similar dashboard, it suggested that you carefully read this article.
2002-2010 Chrysler Sebring PT Cruiser car stereo after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2002-2010 Chrysler Sebring PT Cruiser car stereo installation steps
1. Loosen the trim panel with a lever.
Loosen the trim panel with a lever
2. Take the panel off the dash and disconnect the wires from the car.
Take the panel off the dash and disconnect the wires from the car
2-1
3. Remove the four screws which are holding the unit with a screwdriver.
Remove the four screws which are holding the unit with a screwdriver
4. Take out the unit and disconnect the wire harness at the back of the unit.
Take out the unit and disconnect the wire harness at the back of the unit
4-1
5. Check all the accessories for the new Seicane car stereo.
Check all the accessories for the new Seicane car stereo
6. Connect the harnesses to the back of the new Seicane car stereo.
Connect the harnesses to the back of the new Seicane car stereo
7. Connect the Seicane car stereo to your original car radio’s plugs.
Connect the Seicane car stereo to your original car radio’s plugs
8. Put the new Seicane car stereo into the dash.
9. Turn on the new Seicane car stereo to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
10. Put trim panel back on your new Seicane car stereo after the normal test.
That’s all about the basic steps for a 2002-2010 Chrysler Sebring PT Cruiser car stereo removal and installation. If you cannot solve any problems independently, you’d better contact with your dealer or ask for a professional for help. Besides, it is especially vital for you to have a right replacement for your car. Here I’d like to share a great 2002-2010 Chrysler Sebring PT Cruiser car stereo from Seicane with your as a reference.
Upgraded to a stable Android 4.4.4 operating system and a powerful RK PX3 1.66GMHZ quad-core processor, this Seicane 2002-2010 Chrysler Sebring PT Cruiser car stereo runs faster and smoother as well as has a better performance than ever.
With the assistance of the updated GPS, you are provided with turn-by-turn directions with the latest maps. You can gain the best or shortest route to get to your destinations accurately.
Thanks to built-in Bluetooth connectivity, you are able to sync with your Bluetooth-enabled mobile phone for hands-free calls and music streaming to make a safe and pleasant trip all the time.
What are you waiting for now? With a competitive price, it’s time to take this Seicane 2002-2010 Chrysler Sebring PT Cruiser car stereo right now!
Recent Comments