If you are not satisfied with your factory radio, why not think about replacing it with a new aftermarket car radio? With an ideal car radio installed in your car, you can gain greatest convenience and enjoyment you’ve never experienced before. Today I would like to share a 2011 2012 2013 2014-2015 Kia K2 RIO car radio installation guide from Seicane with you. If you own the same or similar dashboard and would like to replace your factory radio, you can refer to this guide carefully to deal with the installation.
Tips about the installation:
1. Please disconnect the power before the installation.
2. Please prepare a lever and a screwdriver before the removal and the installation.
3. Please keep all the separate parts from the car. Please take great care of the dashboard to avoid scratching it during its detachment and installation. Please keep handy any parts from the car and make use of all the original screws from the car as much as possible. so each related part of the unit can be fixed securely.
4. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2011 2012 2013 2014-2015 Kia K2 RIO car radio installation guide
1. The original car radio.
2. Use a plastic removal tool to release the top panel.
3. Pry the trim panel of the radio with a plastic knife and remove it.Unplug the connector at the back of it.

Pry the trim panel of the radio with a plastic knife and remove it.Unplug the connector at the back of it
4. Unscrew the screws that are holding the radio on the dashboard.
5. Take out the radio gently.
6. Unplug the connectors and cables at the back of the radio.
7. Check all the accessories for the new Seicane car radio.
8. Connect the harnesses to the back of the new Seicane car radio.
9. Connect the Seicane car radio to your original radio’s plugs.
10. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
11. Put the new Seicane car radio into the dash.
12. Put everything into their original place. All the installation is done.
Wish the above installation steps be helpful for you to some extent. If you have any problems you cannot deal with independently, please feel free to consult your dealer, communicate with someone experienced or turn to a professional for help. If you still think it hard for you to finish the whole upgrade process, you’d better go to a car radio upgrade center and arrange a professional technician to help you install the new car radio.
While for the selection of an ideal car radio, if you have no ideas, you can check out the following link, which is a remarkable 2011 2012 2013 2014-2015 Kia K2 RIO car radio from Seicane. Fore more details, please click:
With the assistance of the worldwide real-time GPS navigation system of this car radio, you are able to easily locate where you are currently and find the right way to reach any locations you would like to go to according to the turn-by-turn directions and voice prompts. Besides, this unit comes with dual zone function, which enables you to listen to your favorite music while navigating. And the music will automatically switch to GPS voice.
Under the wireless Bluetooth technology, you are able to make your Bluetooth-enabled mobile pone connect with this car radio so as to get access to both Bluetooth hands-free phone calls as well as Bluetooth streaming music from your phone music playlists. Therefore, you can gain a lot of convenience and enjoyment.
What are you waiting for? If you like this unit, just add it to your shopping cart. Good luck!
Recent Comments