To keep yourself, your families and friends entertained all the way, you can easily count on an intelligent car radio which can not only guide you to your desired destination with the most accurate direction but also offer a lot of entertainment options for you to have great fun in your car. Now I’ d like to share a step-by-step 2007 2008 Jeep Compass (W/Factory NAV) radio installation guide from Seicane with you. If you want to upgrade your factory radio and also have the same dashboard, it’s helpful for you.
2007 2008 Jeep Compass (W Factory NAV) radio after installation
Precautions for this installation:
1.Before you start up any work, park your car well and unplug the negative power cable to avoid any danger.
2.Please make sure that all fastened wires are isolated with electrical tape.
3.Please make sure the ignition is off to avoid short circuit.
4.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2007 2008 Jeep Compass (W/Factory NAV) radio installation guide
1.Loosen the trim panel with a lever.
1.Loosen the trim panel with a lever
2.Take the panel off the dash and disconnect the wires from the car.
2-1.Take the panel off the dash and disconnect the wires from the car.
2-2.Take the panel off the dash and disconnect the wires from the car.
3.Remove the four screws which are holding the original radio with a screwdriver.
3.Remove the four screws which are holding the unit with a screwdriver.
4.Take out the original radio and disconnect the wire harness at the back of the original radio.
4-1.Take out the unit and disconnect the wire harness at the back of the unit.
4-2.Take out the unit and disconnect the wire harness at the back of the unit.
5.Check all the accessories for the new Seicane radio.
5.Check all the accessories for the new Seicane car radio.
6.Connect the Seicane radio to your original car radio ‘s plugs.
6-1. Connect the Seicane car stereo to your original car radio ‘s plugs.
6-2. Connect the Seicane car stereo to your original car radio ‘s plugs.
6-3. Connect the Seicane car stereo to your original car radio ‘s plugs.
7.Put the new Seicane radio into the dash.
7.Put the new Seicane stereo into the dash.
8.Turn on the new radio and have a test if the new Seicane radio is working without problem..
9.Put trim panel back on your new Seicane radio after the normal test.
Can you install your new 2007 2008 Jeep Compass (W/Factory NAV) radio with the help of this instruction? If you think it too hard for you to install it on your own, it’ s strongly suggested you have a professional install it. If you have any question, you can consult your dealer.
In addition, it’ s necessary for you to make clear you have a fitting radio for your car. If you haven’t found one, I’d like to recommend a wonderful 2007 2008 Jeep Compass (W/Factory NAV) radio from Seicane to you. Here’s the link, please click:
With this modern Jeep Compass (W/Factory NAV) radio in your car, a wide range of capabilities are available for you when you replace this unit in your vehicle, like the worldwide real-time GPS navigation system, region-free DVD player, bluetooth technology, FM/AM radio, wifi, TV, etc. Besides, you can add a reverse camera to help you park more easily.
Just enjoy all your trips with this amazing Jeep Compass (W/Factory NAV) radio in your car. Good luck to you!
Recent Comments