If you would like to drive around an unfamiliar place, the worldwide real-time GPS navigation system will help you a lot. However, your factory radio mat not support GPS function of its GPS function is not advanced enough. In that case, you can easily replace it with a modern multifunctional car radio. If you own a 2004 2005 2006 2007-2012 Mercedes Benz A Class W169 A150 A160 A170 and plan to install a new car radio, you can refer to the following 2004 2005 2006 2007-2012 Mercedes Benz A Class W169 A150 A160 A170 car radio installation instruction from Seicane.
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2004 2005 2006 2007-2012 Mercedes Benz A Class W169 A150 A160 A170 car radio installation instruction
1. The original car radio.
2. Remove the air vent with a plastic removal tool and then put it aside.
3. Remove the trim panel with a plastic removal tool.
4. Remove four screws that fixed the radio on the dashboard.
5. Take out the original car radio.
6. Unplug the connectors at the back of the original radio.
7. Check all the accessories for the new Seicane car stereo.
8. Connect the harnesses to the back of the new Seicane car stereo.
9. Connect the Seicane car stereo to your original radio’s plugs.
10. Turn on the new Seicane car stereo to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
11. Put the new Seicane car stereo into the dash.
12. Put everything into their original place. All the installation is done.
Don’t be over worried if you encounter any problems before or during the installation. What you need to do is to calm down firstly, and you can consult your dealer, communicate with someone experienced or seek help from a professional. If you still think it hard for you to remove the factory radio and install the new car radio, you can directly go to a car radio upgrade center to have the new car radio installed by a professional technician. Anyway, it is very essential for you to select an ideal car radio before the installation. If you don’t have any ideas, here I’d like to recommend an amazing 2004 2005 2006 2007-2012 Mercedes Benz A Class W169 A150 A160 A170 car radio from Seicane to you. For more details, please click:
This car radio is loaded with the latest and most stable Android 8.0operation system, a powerful eight-core CPU processor and 32GB INland flash as well as 4GB RAM. So this unit comes higher configuration and better performance to be one of the best replacement for your factory radio.
With the assistance of the turn-by-turn directions and voice prompts provided by the high-end worldwide real-time GPS navigation system, you are able to easily locate where you are and find the right way to reach any locations you would like to go to. Besides, this car radio’s dual zone function enables you to listen to your favorite music while navigating.
Additionally, through the wireless Bluetooth connection between your Bluetooth-enabled mobile phone and this unit, you can dial, answer, reject and mute Bluetooth hands-free phone calls as well as listen to Bluetooth streaming music without taking your hands off the steering wheel.
Wish you have a wonderful driving experience accompanied by this car radio. Good luck!
Recent Comments