As a car owner, if you want to enjoy more convenience and enjoyment in your car, it will be a great ideal for you to replace your factory radio with a new multifunctional car radio. An ideal car radio can bring you a lot of options to provide you with much convenience and enjoyment as well on the way. If you have a 2000-2006 TOYOTA COROLLA EX and plan to replace your factory radio, then you can carefully refer to the following 2000-2006 TOYOTA COROLLA EX car radio installation instruction.
2000-2006 TOYOTA COROLLA EX Car Radio after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2000-2006 TOYOTA COROLLA EX car radio installation instruction
1. Remove two trim panels at each side of the center console and set it aside.
Remove two trim panels at each side of the center console and set it aside
2. Remove the top panel and set it aside.
Remove the top panel and set it aside
3. Remove 4 screws holding the unit with a Phillips screwdriver.
Remove 4 screws holding the unit with a Phillips screwdriver
4. Gently take out the panel on the radio interface.
Gently take out the panel on the radio interface
5. Take out the radio and disconnect cables at back of it.
Take out the radio and disconnect cables at back of it
6. Check all the accessories for the new Seicane car radio.
Check all the accessories for the new Seicane car radio
7. Connect the harnesses to the back of the new Seicane car radio.
Connect the harnesses to the back of the new Seicane car radio
8. Connect the Seicane car radio to your original car radio’s plugs.
9. Put the new Seicane car radio into the dash.
10. Turn on the new Seicane car radio and have a comprehensive check if it works well.
11. Install 4 screws back to their original position.
12. Install the trim panel back to its original place.
Now do you have a general understanding of the installation on a 2000-2006 TOYOTA COROLLA EX? If there are any problems you don’t know how to deal with, you can seek help from your dealer, someone experienced or a professional. Besides, it is very vital for you to pick a suitable car radio among a lot of car radios. If you don’t have any ideas, I’d like to share a great 2000-2006 TOYOTA COROLLA EX car radio from Seicane with you. For more details, please click:
Upgraded to the most advanced Android 6.0 operation system and 8 – Core 1.5 GHz RK-PX5 A53 processor, this car radio can greatly facilitate the operation to provide you with good in-car life.
The high-accuracy 3D GPS navigation system is especially built in for you to know your current locations and gain the most suitable route option to reach your desired destinations according to turn-by-turn directions and voice prompts. Additionally, while navigating, you can freely listen to splendid music thanks to this unit’s dual zone function.
Without taking your hands off the steering wheel, you can dial, answer, reject and mute Bluetooth hands-free calls as well as listen to music streaming from your phone as long as you wirelessly connect your Bluetooth-enabled mobile phone to this car radio.
Wish you like this unit and enjoy your trip. Good luck to you!
Recent Comments