To upgrade your factory radio is actually quite worthwhile, for it can not only provide you with a lot of convenience, but also bring you a huge ton of fun and pleasure. Therefore, more and more car owners try to upgrade their car radios. If you have such a plan, you probably need a detailed installation instruction. Here shows you a step-by-step installation guide about a 2013 2014 2015 VW Volkswagen GOLF 7 car stereo. If you also have the same dashboard as that from Seicane shown as the below, you can take this article as a reference.
2013 2014 2015 VW Volkswagen GOLF 7 car stereo after installation
2013 2014 2015 VW Volkswagen GOLF 7 car stereo installation guide
1）Place the trim panel tool pry the bottom dash panel off and set it aside.
1. Place the trim panel tool pry the bottom dash panel off
2）Place the trim panel tool removal’s blade between the main dash panel and the trim panel surrounding the stereo and climate vents. Pry the panel from the dashboard and set it aside.
2. Pry the panel from the dashboard and set it aside
3）Unplug the wiring between the vent panel and the air conditioner.
3. Unplug the wiring between the vent panel and the air conditioner
4）Unplug the electrical connection from the rear of the radio on the VW Golf 7. These are plug-style connectors so they should pull straight out. If you are having trouble, pinch the top and bottom of the connector and wiggle it back and forth while pulling out.
4. Unplug the electrical connection from the rear of the radio
5）Use four radio unlock tool and unplug your factory radio.
5. unplug your factory radio
6）Disconnect the wiring back of the radio.
6. Disconnect the wiring back of the radio
7）Make antennas and cables of the new Seicane car stereo connected step by step as installation instructions show, and you should be very careful when you are doing this for it will affect whole procedure.
8)Connected the new radio to your VW Golf 7, you should check whether your connections are correct, the new unit is in right position, and you’d better have a tidy for the cables.
10)If everything is OK, make trim panel back on your new Seicane car stereo.
Before and during installation, you should notice:
- Before connecting, please make sure the ignition is off to avoid short circuit.
- Ensure connect the yellow and red power cable at last.
- Ensure that all loose wires are isolated with electrical tape
- Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
- Ensure that all ground is connected to the same place.
- Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
After reading the installation guide, can you remove your old factory radio and install your new radio on your own? If you have any questions during the whole process, you can ask your dealer or a professional for help.
If you don’t have an ideal replacement for your factory radio, you can refer to the multifunctional 2013 2014 2015 VW Volkswagen GOLF 7 car stereo from Seicanel. Here’s the link, please check it out:
With this high-end VW Volkswagen GOLF 7 car stereo in your car, you can not only navigate to your desired destination with the turn-by-turn direction and voice prompts on time, but also enjoy your journey all the way when you utilize the bluetooth technology to stream music from your favorite playlist in your compatible mobile phone or other devices. Furthermore, a backup camera is allowed to be connected with this unit, so that you can easily get access to the parking image when you are reversing.
Just go to your desirable destination with this amazing VW Volkswagen GOLF 7 car stereo on all your trips. Have a great time!
Recent Comments